Electrical Accessories
 

Part Number		Description
EL-600A		Through a limit switch and a solenoid valve, the press controls the action of
		the feed for continuous automatic operation.
EL-600B		With this option the feed controls the press, signaling it when to cycle on
		those jobs which cannot be run fully automatic. MUST BE USED IF
		SPEED OF PRESS EXCEEDS RATED SPEED OF FEED.
EL-600C		This operation will give you a combination of either the feed controlling the
		press or the press controlling the feed, choice of system made be a selector
		switch. Control box set-up.
EL-600D		With a sequential counter and relay system, this option allows the operator to
		control the speed of the feed which controls the press for single stroke or
		multiple stroke long feed-outs before signaling the press or shear to actuate.
		Control box set-up.
EL-600F		Optional cam and limit switch arrangement to actuate air feed.
ASR-900		For piloted dies, only Aero-Matic offers you a simple and positive system of
		releasing the stock from the grippers for pilot pin pick-up. You have only to
		mount the furnished bracket, shaft and limit switch to the crank and wire it
		to the electric valve and set the cam.
Accessories For The Aero-Matic Press Feeds
DMA-501		Double Mounting Angle Bracket
		These two angle brackets together will give you the best mounting for your
		Aero-Matic press feed. The bolster bracket has "T" slots for horizontal
		alignment of the feed when it is mounted to the angle bracket. The angle
		bracket is slotted on the front face for vertical alignment to match the
		material lines of the feed and die set. The top is also slotted.
FMS-710		Floor Mounting Support
		Elevating jack screw and swivel brackets for O.B.I. presses.
O-Ring Tool		Tool used to insert piston around o-ring, available in sizes for both
		standard and x-model air feeds.
DMS-33		Die shoe mount available for 63HD model air feed.

 Back to Home Page